Made from high-quality tungsten carbide, the bit offers excellent strength and wear resistance for long-term professional use. Its fine cross-cut teeth support smooth movement across artificial coatings while helping prevent material build-up on the cutting surface. The slim working tip, measuring 2 mm in diameter, allows careful work near the cuticle and sidewalls, as well as precise treatment of the underside of the natural nail during professional sculpting and correction procedures.

Soft Red (R) is designed for right-handed nail technicians and operates in the Forward rotation direction. Each bit undergoes a centring check to ensure smooth and stable rotation. Precision sharpening and durable tungsten carbide construction contribute to a long service life. According to the manufacturer, the bit provides 2–3 times greater wear resistance than standard drill bits. With proper technique, it helps minimise heat build-up on the nail plate and discomfort during coating removal.

Features:

• Slim corn-shaped cutting head with a fine working tip.
• Designed for right-handed use in Forward rotation.
• Red colour marking indicating fine grit.
• Fine cross-cut teeth for gentle coating removal.
• Suitable for removing thin gel polish coatings and intermediate nail corrections.
• Allows precise work near the cuticle and sidewalls.
• Suitable for detailed treatment of the underside of the natural nail during professional procedures.
• Smooth operation with minimal vibration.
• Helps prevent excessive nail plate heating when used correctly.
• Resists material clogging and does not magnetically attract dust.
• Does not darken after sterilisation when recommended procedures are followed.
• High wear resistance and precision sharpening.

Technical specifications:

• Material: tungsten carbide.
• Shape: slim corn.
• Colour marking: red.
• Grit: fine.
• Cutting pattern: cross-cut.
• Application: artificial gel polish removal and nail correction.
• Rotation direction: Forward, for right-handed use.
• Recommended speed: 25,000–35,000 rpm.
• Cutting head length: 13 mm.
• Shank length: 36 mm.
• Working tip diameter: 2 mm.
• Diameter at the middle of the cutting head: 4 mm.

Care instructions:

1. After each use, remove product residue with a dedicated cleaning brush.
2. Clean the bit using a suitable drill bit cleaning solution or an ultrasonic cleaner.
3. Disinfect according to the recommended solution concentration and contact time. Excessive concentrations may damage the tool.
4. Make sure the bit is completely dry before dry-heat sterilisation. Do not exceed a sterilisation temperature of 180 °C.

Important: Intended for professional use. Exercise particular care when working near the natural nail plate and sensitive areas, control the pressure applied and avoid holding the rotating bit in one spot for too long.