Made from high-quality tungsten carbide, the bit offers excellent strength and wear resistance for long-term professional use. Its fine cross-cut teeth provide precise control over coating removal, while the safe rounded tip allows careful work near the cuticle and sidewalls. The 5.8 mm cutting head diameter ensures smooth movement across the material and helps achieve an even finish.

The bit is intended for use in the Forward rotation direction. Each bit undergoes a centring check to ensure smooth and stable operation. Precision sharpening and durable tungsten carbide construction contribute to a long service life. According to the manufacturer, the bit provides 2–3 times greater wear resistance than standard drill bits. With proper technique, it helps minimise heat build-up on the nail plate and discomfort during coating removal.

Features:

• Corn-shaped cutting head with a safe rounded tip.
• Red colour marking indicating fine grit.
• Cross-cut teeth for gentle, even coating removal.
• Suitable for removing thin gel polish and camouflage base coats.
• Designed for soft artificial coatings and sensitive nails.
• Smooth operation with minimal vibration.
• Allows careful work near the cuticle and sidewalls.
• Helps prevent excessive nail plate heating when used correctly.
• Resists material clogging and does not magnetically attract dust.
• Does not darken after sterilisation when recommended procedures are followed.
• High wear resistance and precision sharpening.
• Rotation direction: Forward.

Technical specifications:

• Material: tungsten carbide.
• Shape: corn.
• Colour marking: red.
• Grit: fine.
• Cutting pattern: cross-cut.
• Application: removal of thin, soft artificial nail coatings.
• Suitable materials: gel polish and camouflage base coats.
• Rotation direction: Forward.
• Recommended speed: 25,000–35,000 rpm.
• Cutting head length: 15.2 mm.
• Shank length: 36.2 mm.
• Diameter at the middle of the cutting head: 5.8 mm.

Care instructions:

1. After each use, remove product residue with a dedicated cleaning brush.
2. Clean the bit using a suitable drill bit cleaning solution or an ultrasonic cleaner.
3. Disinfect according to the recommended solution concentration and contact time. Excessive concentrations may damage the tool.
4. Make sure the bit is completely dry before dry-heat sterilisation. Do not exceed a sterilisation temperature of 180 °C.

Important: Intended for professional use. Control pressure and rotation speed during coating removal, avoid holding the rotating bit in one spot for too long and do not use it for aggressive filing of the natural nail plate.