The high concentration of fibers gives the gel a thick consistency while still allowing it to self-level effectively and perform well in a thin layer. It is suitable for repairing cracks and chips, reconstructing and reinforcing corners, restoring the end line of the free edge, and providing localized reinforcement in the ingrowth area.

After polymerization, the fibers form a strong reinforcing structure within the material, similar to a mesh. This structure stabilizes the damaged area and helps reduce the risk of repeated cracking or breakage. Its high strength also allows the damaged section of the nail to grow out gradually while remaining reinforced throughout wear.

The material is both rigid and strong, with a dense non-porous structure that withstands mechanical stress well. It is resistant to cracking on impact, making it particularly suitable for repairing existing damage and providing reliable support to compromised areas.

Compared with acrygel, DNKa’ Fiber FIX Gel is several times stronger and denser when applied at the same thickness. Unlike acrygel, it has a non-porous structure, self-levels well, and provides reliable reinforcement even in a thin layer. This is particularly useful when reconstructing corners or strengthening the free edge and ingrowth area without adding unnecessary bulk.

• High concentration of reinforcing fibers in the formula.
• Creates a strong reinforcing structure after polymerization.
• Stabilizes damaged areas of the nail.
• Suitable for repairing cracks and chips.
• Ideal for reconstructing and reinforcing corners.
• Suitable for restoring the end line of the free edge.
• Allows localized reinforcement in the ingrowth area.
• Reinforces the free edge without creating unnecessary volume.
• Rigid and resistant to mechanical stress.
• Dense, non-porous structure.
• Self-levels effectively.
• Performs well in a thin layer.
• Helps reduce the risk of repeated cracking and breakage.
• Helps the damaged area of the nail grow out while reinforced.
• Low product consumption.

Method of use:

1. Perform standard preparation of the nail plate by filing the surface and cleansing it with DNKa’ Nail Prep and Cleanser 3-in-1.
2. Apply DNKa’ Dehydrator to the entire nail plate. Evaporation time: 30–60 seconds.
3. Apply DNKa’ Ultrabond to the entire nail plate. Evaporation time: 30–60 seconds. When repairing a crack in the nail bed area, avoid getting DNKa’ Ultrabond directly into the crack.
4. Apply a thin priming layer of the selected DNKa’ base coat according to the nail plate and main material: Multi Base or Fiber Base under a gel system, or Rubber Base or Low Acid Base under gel polish or colored bases. Cure in a 48/36 W LED/UV lamp for 30–60 seconds.
5. Apply a small amount of DNKa’ Fiber FIX Gel only to the area that requires repair. Do not apply the material over the entire nail plate.
6. Cure in a 48/36 W LED/UV lamp for 60/90 seconds.
7. If filing is required after polymerization, remove the sticky layer with DNKa’ Nail Prep and Cleanser 3-in-1.
8. Continue with leveling, reinforcement, or modeling using the selected DNKa’ material.

Ingredients: ACRYLATES COPOLYMER, HYDROXYPROPYL METHACRYLATE, ETHYL TRIMETHYLBENZOYL PHENYLPHOSPHINATE, HYDROXYCYCLOHEXYL PHENYL KETONE, SILICA, NYLON-66

The manufacturer may change the product formulation. Ingredient information may be inaccurate.